Parts & Features - LG WSEP4727 Owner's Manual

50 TROUBLESHOOTING
Parts & Features
Problem
Oven control beeps
and displays any
F
code error.
Displayed colon in
the clock is flashing.
CLEAN and door
flash in the display.
is on in the
Loc
display when you
want to cook.
Oven light does not
work.
Convection fan
stops. (During
Conv.Bake mode)
Fan operation
(During Bake mode)
Oven will not Self
Clean.
Oven door does not
open after a Self
Clean cycle.
The oven is not clean
after a Self Clean
cycle.
Oven racks are
difficult to slide.
Electronic control has detected a fault condition.
• Turn off the oven function you are using to clear the display and stop beeping. Reprogram
oven. If fault recurs, record fault number and call for service.
[Case 1]
- Code: F-3
- Cause: Key short error
[Case 2]
- Code: F-9
- Cause: Oven not heating
This means that the product has just been plugged in, or that it has experienced a
power interruption.
• This is normal. Reset the clock or press any button to stop the flashing.
The Self Clean cycle has been selected, but the door is not closed.
• Close the oven door.
The oven is locked because of the Control Lock feature.
• Deactivate the Control Lock feature.
It is time to replace the lamp or the lamp is loose.
• Replace or tighten lamp. See Changing the Oven Light section in this Owner's Manual.
Convection fan stops during a convection bake cycle. It is done to allow for more even
heating during the cycle.
• This is not a failure of the appliance and should be considered normal operation.
This is to ensure even baking results.
• It is normal for the fan to operate periodically throughout a normal bake cycle in the oven.
The oven temperature is too high to set a Self Clean operation.
• Allow the oven to cool and reset the controls.
Oven controls improperly set.
• See the Self Clean section.
A Self Clean cycle cannot be started if the oven Control Lock feature is active.
• See the Changing Settings section.
Oven is too hot.
• Allow the oven to cool below locking temperature.
The control and door may be locked.
• Allow about one hour for the oven to cool after the completion of a Self Clean cycle. The
door can be opened when the lock
Oven controls not properly set.
• See the Self Clean section.
Oven was heavily soiled.
• Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to
Self Clean again or for a longer period of time.
The shiny, silver-colored racks were cleaned in a Self Clean cycle.
• Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
racks with the paper towel.
Possible Cause & Solution
is no longer displayed.
k