Table of Contents
Advertisement
USING THE 160
SIMULATOR AND FEATURE MEMORY
POWERING UP THE 160
160
After installation, turn the
on by momentarily pressing the Gain knob.
An audible chirp sounds as the unit turns on. If the unit detects that the
160
transducer is connected and is in w ater, the
begins to show sonar
information on the display. If the transducer is not detected, the unit starts
up in simulator mode.
To pow er the unit off at any time, press and hold the Gain knob for several
160
seconds until the
turns off.
Simulator and Feature M emory
160
The
contains a simulator that allows you to use the unit as though you are on the
water. The Simulator is an invaluable aid to learning the features and functions of the
160
. All controls are operational and settings can be changed to experiment with
various features. When operating in Simulator an indicator appears at the bottom left
of the display.
There are two ways to start the simulator. The method to use depends on whether a
transducer is connected:
160
If the
is powered on with no transducer connected, it starts up in simulator mode.
160
No other steps are needed. In this mode the
does not remember any setting
changes that are made.
160
If the
is powered on with the transducer connected, the Simulator must be
manually turned on.
T o manually turn the simulator on:
1. Press the Control Panel knob to display the
list of options.
2. Rotate the Control Panel knob to scroll
through the list until Simulator is visible and is
highlighted on the display.
3. Turn the Range knob to turn Simulator from
OFF to ON.
4. Press the Control Panel knob to clear the screen.
6
Advertisement
Table of Contents
