Table of Contents
Advertisement
In addition to the parts included you need the following for installation and operation:
• A pow ered hand drill and various drill bits
• Phillips and flat-head screw drivers
• A ruler or measuring tape
• Pen or pencil
• 12 volt pow er source (your boat's battery)
• Silicone sealant (for sealing drilled holes)
• 2-part, slow -cure epoxy (for inside the hull transducer installations)
USING THE 160
160 Performance
160 Series
The
Combining state of the art electronics and paper chart recorder sonar
performance, it offers the best of the present and the past. M inimal, easy
to understand knob controls provide access to the most important features.
160
The
eliminates confusion created by too many buttons and menus.
High technology, high performance, w ith " back to basics" operation
160
makes the
160
The
uses sonar to locate and define underw ater objects. Sonar
technology is based on sound w aves sent into the w ater in a controlled
" beam" from the transducer. Objects w ithin this beam reflect the sonar
signal back. The
based on the time it takes for the sonar to return. Each object (bottom, fish
or structure) reflects the sonar uniquely, providing information about its
160
makeup. The
160
The
operates in a w ide variety of w ater conditions, from 2' to 600'.
Actual depth capability depends on many factors such as bottom hardness,
w ater conditions, and transducer installation. All sonar units typically read
to deeper depths in fresh w ater than saltw ater.
represents a new w ay of thinking about fishing electronics.
the ideal choice of the serious angler.
160
very accurately measures the distance to these objects
draw s this returned information on the display.
USING THE 160
160 PERFORMANCE
5
Advertisement
Table of Contents
