Hyundai HHA162206 User Manual page 6

STEP 5 - THE FINISHING TOUCH
1. Finally,use the taper lever without an attachment comb for close trimming around the base of
the neck ,the sides of the neck and the ears.
2. To produce a clean straight line at the sideburns, reverse the hair clipper by turning the
reverse side uppermost (see diagram 7).
3. Press the clipper at right angles to the headtips of the blades lightly touching the skin and
work downwards. This way you will obtain, as a clean cut as would be given by a razor.
SHORT TAPERED STYLES - 'FLAT TOPS' AND SHORTCUTS
1. Starting with the longest attachment comb (12mm) cut from the back of the neck to the
crown. Hold the attachment comb flat against the head and slowly move the clipper through
the hair as shown (see diagram 8).
2. Use the same procedure from the lower side to the upper side of the head as illustrated. Then
cut the hair against the direction in which it grows from the front to the crown and then level
the cut with the sides.
3. To give a 'flat top' look, the hair on top of the head must be cut over the top of a flat comb
ratner than by using the attachment comb.
4. Use closer cutting attachment combs to taper the hair down to the neckline as desired.
Comb hair and check for uneven areas and outlining sideboards and neckline as described
previously.
Diagram 7
Diagram 8