Safety Information - Infineon WLC1150 User Manual

WLC1150 MP-A2 50-W wireless power transmitter
(REF_WLC_TX50W_N1) user guide

Safety information

Safety information
The
REF_WLC_TX50W_N1
software in a laboratory environment. The board is an open-system design, which does not include a shielded
enclosure. Because of this reason, the board may cause interference with other electrical or electronic devices
in close proximity. In such cases, take adequate preventive measures. Also, do not use this board near any
medical equipment or RF devices.
Attaching additional wiring to this product or modifying the product operation from the factory default may
affect its performance and cause interference with other apparatus in the immediate vicinity. If such
interference is detected, suitable mitigating measures must be taken.
The
Electrostatic charges readily accumulate on the human body and any equipment,
which can cause a discharge without detection. Permanent damage may occur to
devices subjected to high-energy discharges. Proper ESD precautions are
recommended to avoid performance degradation or loss of functionality. Store
unused
General safety instructions
ESD protection
ESD can damage boards and associated components. Infineon recommends that the user perform procedures
only at an ESD workstation. If an ESD workstation is unavailable, use appropriate ESD protection by wearing an
antistatic wrist strap attached to the chassis ground (any unpainted metal surface) on the board when handling
parts.
Handling boards
The boards provided with the
the casing, this applies to the boards supplied with a plastic casing. Hold the boards only by the edges. Place it
on a grounded, static-free surface after removing a board from the box/casing. Use a conductive foam pad, if
available. Do not slide the board over any surface.
Do's and don'ts
User guide
reference board is intended for use as an evaluation platform for hardware or
reference board contains ESD-sensitive devices.
REF_WLC_TX50W_N1
REF_WLC_TX50W_N1
REF_WLC_TX50W_N1
Do not touch the inverter output area marked below while the reference board is

in use. The components in this area may operate at a voltage higher than 30 V.
Keep the coil area of the reference board clear from any metallic debris.

reference boards in the protective shipping package.
reference board are sensitive to ESD. When removed from
3 002-36393 Rev. *B
2023-02-06