Running transmitter (tx) and receiver (rx) sensitivity tests on (21 pages)
Summary of Contents for Infineon WLC MP-A2 50-W
Page 1
Infineon’s WLC1150 wireless charging transmitter controller. It supports 50-W wireless charging using Infineon’s High Power Proprietary protocol. It also implements the Qi 1.3.2 specification and supports 15-W wireless charging using Qi Extended Power Profile (EPP). For receivers that do not support EPP, it supports 5-W charging using Qi Basic Power Profile (BPP).
Page 2
Quick start guide Tx interface surface (MP-A2 coil) WLC1150-68LQXQ controller (U2) Power supply mode selection jumper (J4) DC input connector (J3) USB Type-C connector (J1) Dual-color status LED (LED1) REF_WLC_TX50W_N1 board interfaces...
Page 3
Now, the board is ready for use. Powering the REF_WLC_TX50W_N1 board Step 2: Start wireless power transfer using high power proprietary protocol Infineon 50-W 1. Place the Infineon 50-W Rx board on the Tx From USB-C Rx board power adapter Load interface surface of the REF_WLC_TX50W_N1 board.
Page 4
Next steps 1. Download the reference board release package from WLC product page (www.infineon.com/wirelesscharging-ics) 2. See the user guide to learn: • How to configure the firmware parameters and download them onto the Tx reference board using Wireless Charging Configuration Utility and HPI dongle •...