Infineon WLC1150 User Manual page 27

WLC1150 MP-A2 50-W wireless power transmitter
(REF_WLC_TX50W_N1) user guide
Reference board operation
Figure 21 Debug log output
Save the log into a file from Tera Term.
d)
Contact Infineon technical support
e)
Note: If the temperature around the NTC goes below 25°C, it is not required to monitor as the transmitter is
working in a safe operating region. Therefore, the debug log shows the value of NTC TEMP as 25°C until
the temperature around the NTC does not exceed 25°C.
5. Disable debug log in the firmware.
Revert these changes in firmware to default on completion of the process. The debug log consumes the
processor resource, and it is recommended to disable the debug log for optimal performance of the WLC power
transmitter.
User guide
with the captured log files if additional support is required.
27 002-36393 Rev. *B
2023-02-06