Table of Contents
Advertisement
Parameter
Firmware Image Menu
MBA Device Configuration
Menu
iSCSI Boot Configuration
Menu
Blink LEDs
Chip Type
PCI Device ID
Bus:Device:Function
Permanent MAC Address
Virtual MAC Address
Description
Press [Enter] to view firmware image information.
Press [Enter] to configure advanced items.
Legacy Boot Protocol
Š
– Selects non-UEFI Boot Protocol: Preboot Execution Environment
(PXE)/iSCSI.
– PXE, iSCSI, NONE. Default setting is PXE.
Boot Strap Type
Š
– Selects the boot strap type. Options available: Auto Detect, BBS,
– Int 18h, Int 19h. Default setting is Auto Detect.
Banner Message Timeout
Š
– Selects the timeout value. (0 defaults to 4 seconds, 15 is no
delay,1-14 is timeout value in seconds).
– Default setting is 5.
Pre-boot Wake On LAN
Š
– Configures Pre-boot Wake on LAN (WOL).
– Options available: Enabled, Disabled. Default setting is Disabled.
VLAN Mode
Š
– Configures the virtual LAN (VLAN) mode.
– Options available: Enabled, Disabled. Default setting is Disabled.
VLAN ID
Š
– Configures the VLAN ID (1...4094).
– This item is available only when VLAN Mode is Enabled.
Press [Enter] to configure advanced items.
Identifies the physical network port by blinking the associated LED.
Press the numeric keys to adjust desired values (up to 15 seconds).
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller
Displays the MAC address of the Ethernet controller.
Displays the technical specifications for the Network Interface Controller.
BIOS Setup
- 62 -
Advertisement
Table of Contents
