5-3-7 PCH Configuration
Parameter
PCH Configuration
PCH SATA Configuration
Only appears when HDD sets to RAID Mode.
(Note)
Description
Press [Enter] to configure advanced items.
SATA Controller
– Enable/Disable SATA controller.
– Options available: Enable, Disable. Default setting is Enable.
Configure SATA as
– Configures on chip SATA type.
– AHCI Mode: When set to AHCI, the SATA controller enables its AHCI
functionality. Then the RAID function is disabled and cannot be
access the RAID setup utility at boot time.
– RAID Mode: When set to RAID, the SATA controller enables both its
RAID and AHCI functions. You will be allowed to access the RAID
setup utility at boot time.
– Options available: AHCI, RAID. Default setting is AHCI.
Alternate Device ID on RAID
– Enable/Disable Alternate Device ID on RAID mode.
– Options available: Enable, Disable. Default setting is Disable.
SATA Port 0/1/2/3/4/5/6/7
– The category identifies SATA hard drives that are installed in the
computer. System will automatically detect HDD type.
BIOS Setup
- 85 -
(Note 1)