3-4-1 Removing Hard Disk Drive Cage
Read the following guidelines before you begin to install the Hard Drive Middle Tray:
• Take note of the drive tray orientation before sliding it out.
• The tray will not fit back into the bay if inserted incorrectly.
• Make sure that the HDD is connected to the HDD connector on the backplane.
Follow these instructions to install the Hard disk middle tray:
1.
Remove the System Cover. See Section 3-3 Removing System Cover.
2.
Press the release latch on the both side.
3.
Flip over the HDD cage.
2
System Hardware Installation
1
- 25 -