Table of Contents
Advertisement
6. Inside the scoreboard, connect the control cable leads to the appropriate terminals on the
terminal block, according to the label above the terminal block.
NOTE: Refer to the connections that were made at the scorekeeper's location. Make the
connections at the scoreboard match the connections at the scorekeeper's location.
7. Re-secure the signal/power access door to the scoreboard.
RUNNING & CONNECTING THE ELECTRIC SERVICE
NOTE: IT IS RECOMMENDED TO HAVE A LICENSED ELECTRICAN RUN THE ELECTRICAL
SERVICE AND CONNECT IT TO THE SCOREBOARD. A WATERTIGHT, NON-FUSIBLE
DISCONNECT SWITCH, A 20-AMP GROUND FAULT INTERRUPTER, AND A SAFETY GROUND
SHOULD BE INSTALLED FOR THE 20-AMP CIRCUIT CONNECTED TO THE SCOREBOARD. A
120-VOLT CIRCUIT MUST BE AVAILABLE AT THE SCOREKEEPER'S LOCATION FOR THE
CONTROLLER'S 12-VOLT DC WALL TRANSFORMER. IF A BATTERY PACK WAS PURCHASED
WITH THE CONTROLLER, THIS OUTLET BECOMES OPTIONAL.
1. The scoreboard has a ½" knock-out on the lower right corner for bringing in the electrical
service. It can be enlarged if the conduit size is ¾". This is where the conduit from the power
source needs to terminate.
2. The connections are standard black, white, and green (ground). Replace the cover when
complete.
13
Advertisement
Table of Contents
