Table of Contents
Advertisement
THE BLACK, GREEN, AND WHITE WIRES ON THE BACK OF THE WALL PLATE AT THE
SCORING LOCATION.
At the scorekeeper's location:
1. With the communication cable installed between the scoreboard and the 2"X4" wall box, locate
the wall plate provided with your installation hardware.
2. The back of the wall plate has a label indicating how the connections are to be made. Likely,
the insulation will not be the same color on the wires in the cable as that on the wires on the
back of the wall plate. Follow the chart if possible, but more importantly; whatever the match-
up is at the wall plate should also be the match-up at the scoreboard.
3. Secure the junction box cover to the installed junction box.
At the scoreboard:
4. Remove the signal/power access door located on the back of panel A.
5. From the ground, run the control cable through a sealed, water-tight conduit then through a
water-tight conduit fitting into the left side of the signal cable/power access door and into the
scoreboard. A hole is provided for a conduit connector
12
Advertisement
Table of Contents
