Operator Identification - iLine microsystems microINR expert Instructions For Use Manual

2.7 OPERATOR IDENTIFICATION

The user who performs the tests may log on either through the dropdown menu or when a patient or QC test
is initiated, depending on the meter's configuration (see section 3.3).
1. Tap on the status bar in the main menu and then tap on the Log in
button to log on through the dropdown menu.
Select Operator in the User Type section so that the option is highlighted
(bold type with a check mark) and then tap on the Enter ID text entry box.
Enter the identification by means of the barcode scanner by tapping the
Scan OID button if a valid barcode is available. The identification can be
also entered manually using the keypad by tapping the Manual OID button.
Place the barcode at a suitable distance depending on its size to enable
scanning. The meter will emit a beep (provided the beeper is enabled) once
the barcode has been successfully read. The barcode information appears in
Your OID field. The scanner will turn off after 5 seconds if the barcode is not
scanned (the meter beeps and a Scan error or time-out message is
displayed).
Verify and Confirm the Operator ID or tap Back to restart the Operator identification process.
The User icon changes to green on the status bar once an operator has been identified. The operator's
identification will be displayed on the dropdown menu.
Tap the Log out button in the dropdown menu and restart the operator identification process if another
operator intends to use the meter.
Each time the meter is turned off, the identified operator will be automatically logged out.
09