ADJUST THE HEM / CUTTING WIDTH
• Turn the pulley to move the upper blade to the lower dead point.
• Loosen the screw
little to hold the unit in place
• Loosen the screw
Then, tighten the screw
Loosen the screw
•
the lower blade
1
and move the lower trimmer holder
3
and move the upper blade holder left or right till reaching the desired width.
3
1
to return the lower blade holder to its original position and test if the upper and
can cut appropriately
2
to the left. Then, tighten the screw
then tighten the screw
Figure 17
22
1
1
a