HP 37717C Operating Manual page 64

PDH / DSn Testing With The HP 37717C
Multiplexer Testing
4. Set up the
RECEIVE
STRUCTURED SETTINGS
opposite.
The required 34 Mb/s test signal is
selected under 34Mb.
5. Select the logging output required with
the display,
OTHER
LOGGING
function, LOGGING SETUP
then select LOGGING SETUP
and set up the display as
CONTROL
shown opposite.
Start the Multiplexer Test
1. Set up the
RESULTS
opposite.
2. Press to start the
RUN/STOP
measurement.
3. Repeat the test for the other three 34
Mb/s signals, selectable on the
STRUCTURED SETTINGS
G.821 ANALYSIS is selected but any of
the other results can be selected from the
softkey menu without affecting the
measurement.
• The measurement results and alarms are available on the
58
display
as shown
DEVICE
display as shown
RECEIVE
display.
display
RESULTS