Connection And Setup; Inspection Checks; Rj45 Connections; Power Up - Parallax PDT-NSU-7005-MP-I Operation Manual

8. Connection and Setup

8.1 Inspection Checks

Please inspect the unit to ensure that there is no damage to the external casing which could cause a
malfunction of the device or cause a safety critical fault. Any damaged units should be returned to Parallax
Digital Technologies for inspection and testing.
Please ensure that the DC Cables are securely fastened in the terminal block, and that the terminal block is
correctly inserted into the switch power connector housing.

8.2 RJ45 Connections

Ensure all required RJ45 Ports are connected correctly using CAT5e cable or better to the client devices.
The Uplink port should be connected to the host device or network, and the access ports TP1-4 are
available for other devices or connections. All cables should be solid copper and not CCA.

8.3 Power Up

The Unit will automatically power up as soon as DC power is applied to the device. The Power Light will be
illuminated and after approximately 1 second, all of the other LEDs will flash on and off to complete the
initialization sequence. Following this, the Port Status LEDs will display the current state of each of the
ports.

9. Physical Dimensions

All Dimensions are in mm