Electrolux EW6S4225C4 User Manual page 20

20 www.electrolux.com
2. Touch the
the indicator of the set delay goes off.
3. Touch the Start/Pause
again to start the programme
immediately.
12.7 Interrupting a programme
and changing the options
You can change only some options
before they operate.
1. Press
The indicator flashes.
2. Change the options.
3. Press
The programme continues.
12.8 Cancelling a running
programme
1. Turn the programme knob to position
to cancel the programme and to
deactivate the appliance.
2. Turn the programme knob again to
activate the appliance. Now, you can
set a new washing programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
12.9 Opening the door - Adding
garments
If the temperature and level
of the water in the drum are
too high and/or the drum is
still rotating you cannot open
the door.
While a programme or the delay start
operates, the appliance door is locked
and the indicator
1. Touch the button Start/Pause
pause the appliance.
Wait until the door lock indicator
goes off.
button repeatedly until
button
.
again.
is on.
2. Open the appliance door. If
necessary, add or remove the items.
3. Close the door and touch the Start/
Pause
The programme or the delay start
continues to operate.
12.10 At the end of the
programme
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is
activated).
The indicator of the button
The door unlocks and the indicator
goes off.
• The indicator
• Remove the laundry from the
appliance.
• Make sure that the drum is empty.
• Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
• Close the water tap.
• Turn the programme knob to position
to deactivate the appliance.
The washing programme is
completed, but there is water in the
drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The door lock indicator
indicator
locked.
• You must drain the water to open the
door.
To drain the water:
1. If necessary, decrease the spin
speed. If you set
only drains.
2. Press
water and spins.
3. When the programme is completed
and the door lock indicator
to
off, you can open the door.
4. Turn the programme knob to position
to deactivate the appliance.
button.
goes off.
is on.
is on. The
flashes. The door stays
, the appliance
. The appliance drains the
goes