Section 2 Disassembly - Sony BC-WF1000X Service Manual

Wireless noise canceling stereo headset and charging case
Table of Contents

Advertisement

WF-1000X
Note: Follow the disassembly procedure in the numerical order given.
CRADLE NFC BOARD (WITH SHEET (NFC))
Note 1: This procedure is required only when replacing
the WF-1000XL (L-ch). For details, refer to
"REPAIRING AND REPLACING OF THE
WF-1000XL (L-ch)" on page 4.
bottom side
2 screw (B1.4)
(L = 4.0 mm)
front side
top side
3 claw
5 plate (bottom) block
12
SECTION 2
DISASSEMBLY
2 screw (B1.4)
(L = 4.0 mm)
BC-WF1000X
(charging case)
rear side
4 three claws
Turn over.
Note 6: When installing the CRADLE NFC board
to the plate (bottom), check the pattern on
the CRADLE NFC board and install it to
the plate (bottom) in the correct installation
direction.
1 model number label
Note 2: Peel off the model number label carefully so that none of it remains
on the plate (bottom). If it was not successfully peeled off,
completely remove the model number label remaining on the plate
(bottom) before before affixing a new one to the plate (bottom).
Note 3: Replacing only the model number label is not possible. You must
replace these three parts at the same time: WF-1000XL (L-ch),
CRADLE NFC board (with sheet (NFC)), and model number label.
(As repair parts, the WF-1000XL (L-ch), CRADLE NFC board
(with sheet (NFC)), and model number label are supplied as a unit)
front side
rear side
6 Insert a flathead screwdriver in between the CRADLE
NFC board and plate (bottom), and peel off the sheet (NFC).
Note 4: Be careful so that you do not damage the plate (bottom).
If the plate (bottom) is damaged, replace it with a new one.
(Can be replaced individually)
plate (bottom)
7 CRADLE NFC board (with sheet (NFC))
Note 5: Replacing only the CRADLE NFC board is not possible.
You must replace these three parts at the same time: WF-
1000XL (L-ch), CRADLE NFC board (with sheet (NFC)),
and model number label. (As repair parts,
the WF-1000XL (L-ch), CRADLE NFC board (with sheet
(NFC)), and model number label are supplied as a unit)
model number label
CRADLE NFC board
bottom side
OK
NG
pattern
pattern

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wf-1000xlWf-1000xr

Table of Contents