Replacement Of Modules; Beolab 12-3 In Service Position - Bang & Olufsen BeoLab 12-3 Service Manual

4.2

Replacement of modules

BeoLab 12-3 in service position

- Remove all cables from the product
- Loosen screws* holding the front
- Disconnect the two cables to the tweeter
and remove the front as shown
- Use a screwdriver to release the screws (just
been unscrewed) from the speaker and
collect the screws for safekeeping
This is to prevent the screws from falling out
of the product and get lost
- Remove dampers ➀
- Remove screws ➁
- Remove screws
*
TX20
(x2)
12mm
TX20
(x4)
12mm
TX20
(x21)
10mm
➁
TX20
(x4)
22mm
*
Screw w/lock washer
Screw w/lock washer
➀