CyberPowerPC Tracer Liquid Cooling Box Service Manual page 7

7
Disconnect the Water Tubes
When you finished using the Liquid Cooling Box, and intend to
disconnect the Water Tubes, please follow the instructions listed below:
1.Turn off the power by pressing the power button on the Liquid
Cooling Box.
2.Gently squeeze the silver connector which is connected to the laptop
and remove it from the laptop horizontally.
To reduce the possibility of heat-induced injury or equipment overheating:
1. In the case that the connector is connected and the water is not flowing, the
connector may accumulate heat in the metal part because of the temperature generated
by the operation of the system, so please be aware of the high temperature.
2. If you want to remove the quick release connector, make sure the Liquid Cooling Box
is turned off (to avoid water leakage) and test the connector by hand to make sure the
temperature is not too high before removing it.
Squeeze the silver connector and remove
it from the laptop horizontally.