CyberPowerPC Tracer Liquid Cooling Box Service Manual page 4

4
Inject water into the Liquid Cooling Box
1.Open the rubber lid on the Liquid Cooling Box, note that the water
injection hole is quite small (ventilation hole is on the right hand
side), recommend using a syringe or funnel for assistance when
injecting water. Also, distilled water is recommended.
2.After filling in distilled water, long press the power button located
on the Liquid Cooling Box for 4-5 seconds. The power button will
glow in purple indicating entering "Water Injection Mode".
3.Alternatively, open the application "Control Center" in your laptop,
click "Performance" then "Liquid Cooling System Control" module.
Press the "helper" button and click on "Water Injection Mode" to
enter water injection mode.
4.Monitor the water level when injecting the water, add the water
above the MAX indicator for the first time (note. under normal
circumstances, the silver connector will not leak water).
5.Avoid tilting the Liquid Cooling Box, after filling in the water, recap
the rubber lid and make sure that no leakage is observed.
water injection hole