ZENNE KGS Series Operating Instructions Manual page 6

Gas Type
Zenne
Table Top
KGS201C-S
Model No.
For LP Gas 2.8kPa
Gas Consumption: 7.20kW
19.05.000001
030519
Zenne Infinity Sdn. Bhd.
Lot 1863, Jalan Kolej,
SIRIM 43300 Seri Kembangan,
MS1535:
PART 2 : 2002 Selangor, Malaysia.
PC004178 Made in Malaysia
Example:
KGS-201C-S L.P. Gas
Zenne
Table Top
KGS201C-S
Model No.
For LP Gas 2.8kPa
Gas Consumption: 7.20kW
19.05.000001
030519
Zenne Infinity Sdn. Bhd.
Lot 1863, Jalan Kolej,
SIRIM
43300 Seri Kembangan,
MS1535:
Selangor, Malaysia.
PART 2 : 2002
Made in Malaysia
PC004178
Gas Hose Installation
Hose Clip
End of G-Pipe marked in red
Rubber
Hose
( ONLY Applicable
in Malaysia )
Fit the certified ZENNE LPG hose ( BS3212 : MS2086 ) tightly over
the end of the gas supply line and secure it with a hose clip. If the
rubber hose is not secured tightly, it may cause a gas leak or even
an explosion.
Ensure that the gas hose is cut to the correct length (less than 2 m)
and not bent during installation.
Bending, twisting or stretching may break the gas hose and cause a gas leak.
Gas hose is too short. The stress and tension caused
by stretching may break the gas hose in the long term.
The hose connection at either the regulator or behind
the gas cooker can easily be loosened.
Gas Hose Replacement
• It is recommended for the gas hose to be
replaced every three years.
When replacing gas hose, trim off 50mm
from the connecting end of the new hose
(as shown in the diagram).
This is to prevent any loose connections
that may cause gas leak.
• Sometimes, the end of the connecting
hose may have been overtightened or
torn. Thus, the part would have weakened
or lost its durability and elasticity in the
long term.
Perform a leak test on the
connections after changing
the hose to avoid any gas
leaks. (Please refer to Page 2
on 'Detecting A Gas Leak')
GAS COOKER INSTALLATION
Case Side
Use only the type of gas
specified on the side label.
If the type of gas used is incorrect,
it can cause combustion, carbon
monoxide poisoning, fire, and
other hazards.
Hose entangled in loops. This may
slow down gas flow.
Ensure that all connections
are secured with a hose clip.
Zenne
Regulator
(ZR2017BT & ZR2018BB)
(ONLY Applicable in Malaysia)
Gas Hose Connection
Ensure that the gas hose
is not in contact with any
part of the gas cooker
while cooking.
' Y ' - connector
Gas
hose
clips
DO NOT diversify the gas supply line. This may cause gas leaks,
which can results in an explosion or gas intoxication. ONLY use an
approved gas hose. Do not use a PVC hose as it has low heat
resistance. Minimise hose joining and avoid using "Y" or "T"
connector.The connection of the gas cooker MUST be performed
by a qualified person according to L.P. Gas standards.
Remove 50mm off hose end.
Hose clip
5
' T ' - connector
Gas
hose
A sharp bend on the gas hose can
affect gas flow. The affected section
may crease, wrinkle or even puncture.
PLEASE
PAY ATTENTION
TO THE
CONNECTIONS
Rotary Inlet
(Behind gas cooker)
Hose & Clip
Gas
hose
clips