Cleaning & Maintenance - ZENNE KGS Series Operating Instructions Manual

Auxiliary Trivet
USAGE:
The auxiliary trivet is used when the base of the pan
or wok size utilised during cooking is too small to be
supported by the main trivet. Hence, this optional
part is used to provide extra support.
Top
Note:
Wear safety gloves when cleaning
and carrying out maintenance
to avoid injury.
- DO NOT place metal sheets, wire gause
or aluminium plates on top of the burner
for cooking purposes as this will cause
irremovable stains on the top plate.
Glass Top
( for GST211)
When cleaning tempered
glass top, wipe it with a
soft, damp cloth and mild
detergent.
DO NOT use metallic sponge,
sharp chisel or scraper to
clean the glass surface when
removing sticky food residue.
This may create scratch marks.
Flame Failure Device
If the tip of the sensor is covered up with food residue caused by burnt overflow, porridge and
so on, please DO NOT use rough metal scour or scrapper to clean it as this may dent and spoil
the sensitivity of the sensor's tip.
Turn the ignition knob back to 'OFF' position (Step 1), and DO NOT attempt to reignite the gas
cooker. Use only soft brush, sponge or soft cloth with warm water and dishwashing detergent
(Step 2). Wipe off the dirt or food residue covering the tip of the sensor prior to igniting the gas
cooker again (Step 3) .
1
(Usage & Caution)
Should the auxiliary iron trivet be used during cooking, please DO NOT turn the knob
to the maximum flame. The intense heat from the flame may soften and burn the trivet
until its surface turns red hot.
CLEANING & MAINTENANCE
DO NOT USE:
• PVC / Metal Brush
• Alkaline detergent / Petrol / Corrosive
or Bleaching Material
- Use a soft cloth or soft sponge with
mild or neutral detergents to wipe the
top plate.
- DO NOT use a PVC or metal brush to
clean it.
- DO NOT use alkaline detergent,
petrol, corrosive or bleaching material.
These cleaning materials may
permanently damage the surface
finishing (non-stick coating and
stainless steel material).
2
USE :
• Burner Cap: LOW Flame
• Small Burner Cap: STANDARD Flame
Trivet
Wipe and clean the trivet
regularly to prevent corrosion.
Use a soft brush to remove
any dirt or food residue
covering the tip of the
sensor.
9
CAUTION :
DO NOT USE :
• Burner Cap: Highest Flame
• Small Burner Cap: Highest Flame
Polisher
Thinner
Gasoline
Metal
Rigid Nylon
Scrubber
Brush
TIPS:
If the gas cooker will
not be used for some
time, keep the burner
clean and cover the
gas inlet to prevent
build-up of dust or
spider webs etc.. This
may lead to ignition
problems when you
try to use at a later
time.
3
Alkaline
Detergent