Dedicated Micros Digital Sprite 2 Setup Manual page 7

Important Safeguards
Read Instructions
All the safety and operating instructions should be read before the unit is operated.
Power Sources
This unit should be operated only from the type of power source indicated on the manufac-
turer's label.
Servicing
Do not attempt to service this unit yourself as opening or removing covers may expose
you to dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
Ventilation
Ensure unit is properly ventilated to protect from overheating.
All the safety and operating instructions should be read before the unit is operated.
To prevent fire or shock hazard, do not expose this e�uipment to rain or moisture. The lightning flash
with arrowhead symbol within an e�uilateral triangle is intended to alert the user of this e�uipment
that there are dangerous voltages within the enclosure which may be of sufficient magnitude to
constitute a risk of electric shock.
WARNING
This is a class A product. In a domestic environment this product may cause radio interference in
which case the user may be re�uired to take ade�uate measures.
Lightning Strike
The unit has some inbuilt protection for lightning strike, however it is recommended that isolation
transformers be fitted to the system in areas where lightning is a common occurs.
Regulatory Notes and FCC and DOC Information
(USA and Canadian Models Only)
Warning�� This e�uipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part �5 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be re�uired to correct the interference at their own expense.
If necessary, the user should consult the dealer or an experienced radio/television technician for
corrective action. The user may find the following booklet prepared by the Federal Communications
Commission helpful�� "�ow to Identify and Resolve Radio-TV Interference Problems".
This booklet is available from the US Government Printing Office, Washington, DC�040�, Stock No.
004-000-00345-4.
This reminder is provided to call the CCTV system installer's attention to Art. 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as close to the point of cable entry as practical.
Dedicated Micros ©2007