Direct Code Set Up - One for All URC-6210 Instruction Manual

To set up the ZAPPER for your Television follow the instructions below.
1 Find your Television code in the Set-Up Code section (page 82-107). Codes
are listed by brand name. The most popular codes are listed first.
2 Make sure your TV is switched on (not on standby).
3 Press and hold the MAGIC key until the LED blinks twice (The LED
underneath the POWER key will blink once then twice).
4 Enter your 5-digit code according to the chart below.
The LED underneath the POWER key will blink twice.
VOLUME - = 2
5 Now, aim the ZAPPER at your Television and press POWER. If your
Television switches OFF, your ZAPPER should be ready to operate your
device.
4

Direct code set up

CHANNEL + = 3
CHANNEL - = 4
VOLUME + = 1
MUTE = 5
WWW.ONEFORALL.COM