Cable Information; Supplier's Declaration Of Conformity - NEC PV800UL-W Important Information Manual

If it is expected that spectators will intrude
into the hazard zone when installed on the
ceiling, it is necessary to prevent specta-
tors from entering that area.
CAUTION
If the precautionary zone between the
floor and the hazard zone cannot be se-
cured, it is necessary to prevent spectators
from entering the area around the screen
as shown in the figure on the right.
* If using lens shift, please consider the shift of projected image according to
the volume of lens shift. Installation example considering the precautionary
zone
CAUTION
Please follow all safety precautions.
Installing the projector
• When planning the layout of the projector, make sure to follow
the safety measures listed in the installation manual.
• In order to avoid danger, either install the device within easy reach
of a wall outlet or provide a device like a breaker to disconnect
power to the projector in emergency.
• Take safety measures to prevent human eyes from entering the
hazard zone.
• Select an appropriate lens for the installation location and secure
the safety zone set for each lens.
Ensure that appropriate safety measures have been taken when
operating the projector, adjusting the light, etc.
• Check whether the appropriate safety zone for the installed lens
has been adequately secured.
Periodically check the zone and maintain a record of verifications.
The installer or dealer must instruct the manager (operator) of
the projector of the following:
• Educate the manager of the projector (operator) about safety
before operating the projector.
• Instruct the manager of the projector (operator) to perform inspec-
tions (Including safety checks on light emitted by the projector)
before powering the projector on.
• Instruct the manager of the projector (operator) to be able to
control the projector whenever the projector is powered on in
case of an emergency.
• Instruct the manager of the projector (operator) to keep the
installation manual, user's manual and inspection records in an
easy-to-reach place.
• Instruct them to determine whether the projector conforms to the
standards of each country and region.

Cable information

Use shielded cables or cables attached ferrite cores so as not to interfere
with radio and television reception.
FCC Information (for USA only)
WARNING
• The Federal Communications Commission does not allow any
modifications or changes to the unit EXCEPT those specified by
Sharp NEC Display Solutions of America, Inc. in this manual. Failure
to comply with this government regulation could void your right
to operate this equipment.
• This equipment has been tested and found to comply with the
limits for a class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equip-
ment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at
his own expense.

Supplier's declaration of conformity

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions.
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
U.S.Responsible Party:
Address:
Telephone Number:
Type of Product:
Equipment Classification: Class A Peripheral
Model Number:
Notice Concerning Electromagnetic Interference (EMI)
(For other regions)
WARNING:
Operation of this equipment in a residential environment could
cause radio interference.
EN-9
Sharp NEC Display Solutions of America,
Inc.
3250 Lacey Rd, Ste 500
Downers Grove, IL 60515
630-467-3000
Projector
NP-PV800UL-W/NP-PV800UL-B/NP-
PV710UL-W/NP-PV710UL-B