Are Range Rings Displayed - NorthStar Ethernet Radar Install Manual

APPENDIX B: Troubleshooting
Note: There are two styles of power cords with two different wiring configurations.
Radar Power Cable
Connector End View
Gnd
5 1
4 2
NC
3
NC
Old style:
To radar control unit
Newer style, Rev C or later:
To radar control unit

Are Range Rings displayed?

Yes, range rings are displayed
1. Confirm that the installation setup has been performed.
2. Verify that the array is turning. If it's a dome, with the power off, remove the dome cover
(weather permitting). Apply power to the system. After the warm-up countdown has
completed, and the transmit option is set to ON, verify that the array is turning.
If the antenna does not turn, skip to the next section titled If the array or antenna fails to turn.
No, range rings or range scale information are not displayed.
1. Verify that the Ethernet wiring is correct.
Page 32
Pin Function
DC –
1 DC Power – Gnd
2 DC Power – A+
3 Not Connected
DC +
4 Not Connected
5 Equipment Ground
Power cable
Power cable
Color (new style) Color (old style)
Black
Red
Green
Note: Some older cables used a Gray wire for ground
and white for DC+.
Gray
Ground
Black
To power source
DC –
White
DC +
Note: Some older cables used a Gray wire for ground
and white for DC+.
Green
Ground
Black
To power source
DC –
Red
DC +
Ethernet Radar Installation Manual, Rev. A
Black
White
Gray