NorthStar Ethernet Radar Install Manual page 10

SECTION TWO: Installing and wiring the radar
NOTE:
Referring to Figure 5 below and the supplied full-size antenna mounting templates, drill holes at the
specified locations in the mounting base. Using these holes and hexagonal bolts, install the antenna
to the mounting base. Use silicone to stop the bolts from loosening. The bolts supplied will suffice for
mounting base thicknesses of 0.35 to 0.55 inch (9 to 14 mm). If the mounting base is thicker or thin-
ner than that, use bolts specified in Table 3 or Table 4 on page 7. See Figure 6 or Figure 7 below for
details on bolting the antenna to the mounting base.
Figure 5: Hole positions for mounting antennas (radome or open array)
Page 6
When the radar platform or mounting bracket has a curvature of more than
2mm, repair it or use spacers.
Ethernet Radar Installation Manual, Rev. A