NorthStar Ethernet Radar Install Manual page 11

Mounting a radome
Thickness of
mounting base
0.04-0.16 in. (1 - 4mm)
0.16-0.35 in. (4 - 9mm)
0.35-0.55 in. (9 -14mm)
0.55-0.75 in. (14 -19mm)
Mounting an open array
Remove the protective cap covering the rotary coupler on the top of the antenna. Match the antenna
radiation direction to the direction of the arrows on the rotation base as shown in Figure 8, and
secure the antenna into place using four M8 bolts.
Ethernet Radar Installation Manual, Rev. A
TABLE 3: Bolts for mounting radome antenna
Radome mounting bolts
M10 × 15 (1.5mm pitch)
M10 × 20 (1.5mm pitch)
M10 × 25 (1.5mm pitch)
M10 × 30 (1.5mm pitch)
SECTION TWO: Installing and wiring the radar
Figure 6: Mounting the radome antenna
Material
Stainless
Stainless
Stainless
Stainless
Figure 7: Mounting the open array antenna
Comments
Included
Page 7