Aspen Pumps mini orange Installation & Maintenance Manual

BEFORE SERVICING OR TROUBLESHOOTING ENSURE THE PUMP IS DISCONNECTED
FROM MAINS SUPPLY.

Servicing:

• This Pump, like all mechanical equipment, requires periodic and regular maintenance.
• Reservoir and filter should be removed and cleaned with anti-bacterial solution, and
all tubing should be checked for leaks at maximum 3 month intervals during cooling season.
• Reservoir must be replaced flat & horizontal after removal for any reason.

Troubleshooting:

Fault: Pump runs all the time.
1. Is float present on sensor column?
2. Is float fitted with magnet facing upwards?
3. Is reservoir lid firmly seated on reservoir with float located around sensor column inside reservoir.
4. Is plug on sensor cable correctly and tightly inserted into socket on pump case and are terminals dry?
5. Is there sludge on reservoir bottom preventing float from resting on the bottom. This may occur if
pump has been in operation for some time without cleaning.
Clean reservoir and float with anti bacterial solution.
6. Does evaporator produce more condensate water than pump can handle. If so,
pump is too small and must be replaced with larger unit or different type.
NOTE:
AFTER INSTALLATION AND DURING OPERATION, PRESENCE OF AIR IN PIPE BETWEEN
RESERVOIR AND PUMP INDICATES A BACKFLOW PROBLEM.
REFER TO GUIDELINES ON PAGE 3 TO REMEDY THIS.
PUMP WILL ONLY SWITCH OFF WHEN FLOAT IS RESTING FLAT ON BOTTOM OF RESERVOIR.
Fault: Pump stops and starts and makes a loud noise.
1. The water is backflowing into the pump. Follow guidelines on page 3 to prevent backflow.
Fault: Pump runs but does not pump any water.
1. Check for air leaks in the pipe between reservoir and pump. Use cable ties to to ensure an airtight seal.
2. Check that reservoir and inlet tube are free of sludge and debris.
Fault: Pump doesn't operate.
1. Is voltage correct?
2. Check fuse for continuity.
3. Is pump correctly wired?
4. Is power reaching pump?
5. Is pump very hot? A thermal cut-out may have been activated to protect pump.
This will automatically reset once pump has cooled down.
WARNING:
1. SIZE PUMP TO HANDLE MAXIMUM CONDENSATE FLOW UNDER WORST CASE CONDITIONS.
2. CHECK PUMP FOR CORRECT VOLTAGE BEFORE STARTING INSTALLATION.
3. INSTALL, PIPE AND WIRE STRICTLY IN ACCORDANCE WITH MANUFACTURERS INSTRUCTIONS.
4. DO NOT OPERATE PUMP WITHOUT FILTER.
5. DO NOT RUN PUMP DRY, SERIOUS DAMAGE WILL OCCUR AND INVALIDATE WARRANTY.
6. INSPECT PUMP REGULARLY AND CLEAN RESERVOIR AND FILTER. FLOATSWITCH MUST OPERATE FREELY
AT ALL TIMES.
7. DO NOT LEAVE SITE WITHOUT TESTING PUMP FOR CORRECT OPERATION AFTER INSTALLATION AND
MAINTENANCE.
7
Thank you for buying your new Mini Orange Pump.
This manual provides complete instructions for the correct installation and maintenance of pump which should
be carefully followed. Please record following information for future reference:
Serial number:
Date installed:
Imported and Distributed by:
3 Kellogg Court, Unit 10, Edison, NJ 08817 Tel: 732-248-8066 Fax: 732-248-8068 email: info@eztrap.com website: www.eztrap.com
Product Warranty
The manufacturer disclaims all implied and express warranties, including the implied warranty of merchantability and the implied warranty of fitness for a particular purpose, except as follows:
The EZ-Trap condensate product purchased by you concurrently is unconditionally warranteed to be free from defects in material and workmanship under normal use for a period of one year from date
of purchase, providing it is installed and operated strictly in accordance with the manufacturer's installation instructions. If the product is found to be defect or otherwise fails in normal use, you may
return it for replacement. All freight charges for the return of the product shall be borne by you. The manufacturer will pay outgoing freight charges for the replacement product. Defective product
returned to the factory prepaid will be repaired or replaced free of charge. Replacement product will, to the extent such product is then available in the manufacturer's inventory, be of a similar type of
color and kind. Manufacturer retains the right to substitute product if the replacement product does not conform in terms of color, type and specifications to the original product if no longer available.
This warranty does not cover replacement labor or any cost, claim or incident to any defect nor does it cover any consequential damages. The sole liability of the manufacturer under this warranty is
limited to the replacement of defective product. Product damaged by improper use, accident, neglect, alteration, abuse or improper installation is excluded from this warranty.
Part No. 1810
Manufactured by: Aspen Pumps Apex Way Hailsham East Sussex BN27 3WA United Kingdom website: www.aspenpumps.com
mini orange pump
INSTALLATION & MAINTENANCE MANUAL
FOR MODELS ASP-MO115 & ASP-MO230
•
false ceiling where possible, inside casing
of minisplit evaporator unit where space
•
Operating Voltage:
Location of pump:
®
Designed for installation above a
permits or inside lineset cover
•
Quick and easy to install
The Mini Orange will quietly and
reliably pump condensate water
to a maximum height of 26 feet
•
2 reservoir options supplied
for installation flexibility