Panasonic NR-TZ601B Operating Instructions Manual page 5

Usage precautions
When using:
When the plug is disconnected, leave it for 5 minutes before
plugging again. If not, the compressor may not work.
Adjust the temperature according to the actual operating
condition for energy saving.
The humidity inside the fresh case may condense so wipe it
with a cloth periodically. Clean the fresh case once a month.
If you will not be at home for several days and there are nothing refrigerated in
the refrigerator, the plug should be disconnected for energy saving.
The outside wall of refrigerator cabinet may sometimes get warm, especially
just after installation. This is quite normal, and is due to the built-in Mullion Dryer
Pipe which prevents sweating and radiates heat.
When humidity is high, e.g. during rainy-season, condensation may appear
on the surface of cabinet, especially around the door seal gasket. Wipe off the
condensed water with a clean cloth.
Do not keep the door open any longer than necessary, particularly in hot, humid
weather.
When storing food:
Do not place warm/hot foodstuff in the refrigerator.
Do not overload the refrigerator. Gap must be provided between
foodstuffs to maintain the cooling effect.
Store fruits and vegetables in vegetable case, where trapped
moisture helps preserve food quality for longer time periods.
Drinking water, beverage bottles should be sealed to prevent
odor contamination.
Food stuff such as vegetables, fruits and fresh food should be
wrapped or packed in box before freezing and refrigerating.
store for an extended period.
Cool hot dishes in room temperature before placing them in your
refrigerator.
SPECIAL FEATURE
1) ECONAVI
The microchip performing ECONAVI mode is integrated into the main control board. By
detecting refrigerator's frequency of use (opening and closing of door), ECONAVI mode
automatically operates to save energy.
2) INVERTER
In accordance with temperature change inside the compartment, the motor of compressor
runs at different speed. When the temperature is stable, the motor runs at a lower speed
(energy saving & lower noise). When powerful cooling is required, the motor runs at a
higher speed.
5 mins