Advertisement
Service Information
10.5 – Offboard Diagnostic Information System Service (ODIS Service)
VAS 6160-VPC diagnostic tablets are eligible and recommended for the initial installation of ODIS Service
diagnostic software and subsequent update installations.
To install ODIS Service, prepare the tablet, request the license, install and configure the software etc. in
order, exactly as specified in the following Service Information document titles:
ODIS Service Installation Phase 1 - Preparation and License Request Instructions (eShop)
ODIS Service Installation Phase 2 - Software Installation & Configuration Instructions
ODIS Service Installation Phase 3 - Security Certificate Request & Installation Instructions
All ODIS Service installation documents are located in the Workshop Equipment – ODIS Service > ODIS
Service > Service Information section in ServiceNet.
When installing ODIS Service, always use the latest installation and update DVD versions!
11.0 – Import GeKo Certificate for VAS-PC Operation
As indicated on the
"STOP!
Certificate Maintenance request form must first be completed and submitted to VWGoA Network Security.
The GeKo security certificate must be imported prior to using VAS-PC for immobilizer adaptation, SVM etc.
Notes
Prior to filling in the GeKo Certificate Maintenance request form, start the VAS-PC application
and select the Administration function. Note the Equipment Number displayed in the upper
right information header, and enter this number into the appropriate field in the certificate
request form.
Proceed with the instructions in this section only after receiving confirmation that the
certificate is staged and ready to import.
Use your existing VAS Commander CD V03.00.00. Remember that this CD would have been
used to import the GeKo Certificates to your existing VAS diagnostic devices currently in
service!
If you require assistance with this information in this section, contact your dealership system
administrator or the IT Service Desk at: 866-892-3375
Prerequisites:
Device mounted in base station (port replicator).
Active internet connection available and Ethernet (network) cable connected.
VAS Commander CD V03.00.00 on hand
Procedure:
1. Insert Commander CD V03.00.00 into the CD-DVD drive in the base station (port replicator). The CD
should start automatically (could take up to three minutes to start).
© 2013 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may
be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be
modified or reposted to other sites, without the prior expressed written permission of the publisher.
- Attention Service Manager" shipment cover letter, the supplied GeKo
Page 15 of 22
Advertisement
