Advertisement
Service Information
15. Go to the Base installation document section "3.0 - Perform Base Software Installation".
16. Follow the instructions (in order) in subsections "3.1 - Uninstall Previous Base Software" and "3.2 -
Install Base Software V19.01.XX".
17. When the current Base software version installation is complete, proceed to Section 10.3 - Configure
VAS-PC Base Software below.
10.3 – Configure VAS-PC Base Software
Note
The Importer number and the Dealership number entry can only be performed once. Ensure
they are entered correctly as instructed with the next steps.
1. From the VAS-PC Main / Start screen, select Administration and then Enter workshop code.
2. Enter the Importer number using the virtual keypad: For the US market, the Importer Number is 444.
For the CDN market, the Importer Number is 999. Press Q.
3. Enter the last five digits of your Dealership number, and then press Q. Use substitution of alpha
characters as follows: A=1, B=2, C=3, D=4, E=5, F=6, G=7, J=8, S=9 & W=0.
4. After confirming the input, select OK to proceed. Selecting Cancel will allow re-entry of the Importer
number and Dealership number.
© 2013 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may
be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be
modified or reposted to other sites, without the prior expressed written permission of the publisher.
Page 13 of 22
Advertisement
