Page 1
WE-EF LIGHTING Installation and Maintenance Instructions Wall Luminaires Surface Mounted PLS420 LED PLS430 LED Surge Protection Do not open during installation This product is factory-sealed. This product features built-in surge protection circuitry in compliance Refer to the instructions contained in this with applicable standards.
Page 2
Wall Luminaires Surface Mounted PLS420 PLS430 IP66, IK08. Class I, ta = 40°C...
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high-pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried Warning: Do not open luminaire while mains supply is switched on.
Installation The product must be installed and maintained by a building/construction and/or electrical regulations and relevant legislation. Warning: Notice: no longer be valid and shall become the full responsibility of the modifying person/organisation. Claims based on defects attributable to improper installation and/or application, and the consequences thereof, are excluded.
Installation Procedure 2a) ON-OFF version 2b) Dimming versions (0-10 V) A from luminaire housing A from luminaire housing B by loosening screws C B by loosening screws C connector D. connector D. Remove terminal cover L.
Page 6
Fixture is intended to be mounted over a UL 131-XXXX SOE XXXXXXX listed junction box (not supplied by WE-EF), LED 3000K 18W item no. XXX use provided wall plate to cover boxes larger than the outer dimensions of the luminaire.
Page 7
7) Connect leads of mains supply cable H (and second cable I for through wiring, if required) to respective terminals of socket K: a) ON/OFF (L = Phase, N = Neutral, b) 0-10 V (L = Phase, N = Neutral, = Earthing) = Earthing, D–/D+ = 0-10 V control line).