GLO HYPER X2 User Manual
Hide thumbs Also See for HYPER X2:

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HYPER X2 and is the answer not in the manual?

Questions and answers

Summary of Contents for GLO HYPER X2

  • Page 2: Safety Instructions

    SAFETY INSTRUCTIONS Do not disassemble or tamper with your glo™ tobacco heater or Please read this user guide before use and keep it for future reference. USB Cable. Any inappropriate, incorrect, or irresponsible use will void any warranty and could result in serious injury.
  • Page 3: What's In The Box

    Welcome to glo™ What’s in the box glo™ tobacco heater and all the accessories contained in the starter kit are designed and manufactured with high quality materials and components, some of which may be recycled and reused depending on your local electrical waste processing infrastructure.
  • Page 4: Product Diagram

    Product Diagram 1. Heater entrance 2. Shutter door 3. LED ring display 4. Boost button 5. Standard button 6. USB charging port 7. Cleaning door...
  • Page 5 Up to 75% charged Up to 95% charged 100% charged The glo™ tobacco heater may take up to 3.5 hours to be fully charged at ambient temperature. The glo™ tobacco heater can be used whilst plugged in as long as it has enough charge. However, charging will be paused until the session is complete.
  • Page 6 03 Turn on This glo™ tobacco heater has two heating modes: Standard Mode Start-up Boost Mode Start-up 'STANDARD' and 'BOOST'. (30 seconds) (20 seconds) You can choose either a STANDARD or BOOST mode when you start a session. Starting a session:...
  • Page 7 Discard a prince-stick responsibly in a waste bin. left of the session the device will vibrate and the LED Always ensure the shutter door is closed after every display will pulse. The glo™ tobacco heater will then session. turn o automatically.
  • Page 8: Charge Status

    The status cool for a minimum of 5 minutes before cleaning. of the charge level cannot be checked during a Open the cleaning door at the bottom of the glo™ session. tobacco heater. Use a tissue to wipe away any See instruction 1 for further information on charging.
  • Page 9 Simply rinse brush under running water. Please make sure that the cleaning brush is dried when using again with glo™ tobacco heater. WARNING! ATTEMPTING TO REMOVE DEBRIS BY FIRMLY TAPPING OR SHAKING THE glo™ TOBACCO HEATER MAY RESULT IN DAMAGE...
  • Page 10: Troubleshooting

    10 Troubleshooting Error Code Possible Cause Suggested Action Low battery Charge device • Battery temperature • Do not start a new session and wait for a few outside of limits. minutes or until the device temperature has stabilised. • Battery voltage outside of limits.

Table of Contents

Save PDF