Configuration & Tune-Up Tma-296; Settings With Rotary Encoders; Figure 4: Front Face; Figure 5: Encoders & Leds - icoms TMA-296 User Manual

CONFIGURATION & TUNE-UP TMA-296
The TMA-296 is equipped with two encoding wheels for manual setting. It is also equipped with an RS-232 link
giving access to a wide range of parameters.
By default, the settings are made via the encoder wheels
At start-up, the LEDs indicate the version number and the type of configuration:
- Green and red LEDs flash alternately: relay check
- Flashing green or red LED: version number
•
If the green LED flashes, the configuration comes from the encoder wheels
•
If the red LED flashes, the configuration comes from the parameters sent via RS-232
If the radar has been configured via RS-232 and the position of an encoder is subsequently changed while the radar
is powered, the radar switches to encoder configuration.
To switch to the RS-232 configuration, it is necessary to switch the parameter to "RS-232" (see 2.2.1.1, p. 12).
1

SETTINGS WITH ROTARY ENCODERS

You can set different parameters through 2 encoders allowing 16 positions each.

Figure 4: front face

Figure 6: front face with/without sticker

Encoder
Encoder
1
Figure 5: encoders & LEDs
Once you have set the requested radar
parameters, place the sticker on the front face to
guarantee its water tightness.
ATTENTION: manufacturer's warranty does not
cover radars without sticker!
2
9