Table of Contents
Advertisement
Switching off
5.2 Switching off
– Long press ON/OFF.
The instrument will beep twice if settings have been
changed and power down.
AutoSigma 3000
5.3 Changing working parameters
Follow the sequence in section 3.5.
H
Note:
The settings of some parameters are dependent on
others and if a confl ict is encountered error messages
will appear on the screen and/ or the instrument will
beep. Some are as follows:
With an 8 mm (two digit) probe code in place, you can-
not select a frequency of 60 kHz (only useable with
12.7 mm probe). If it is attempted the instrument will
beep and not carry out the change. It is then neces-
sary to move to the PROBE parameter and recall
the correct four digit code number appropriate to the
12.7 mm probe to be used.
When the set probe routine is being carried out, if the
wrong probe code is in place i.e. two digit number is
present (8 mm probe) when trying to set a 12.7 mm
probe which should have a four digit code number or
vice-versa. The display will show an error (see Fig-
ure below), and will prompt a press of the SET button
Issue 04, 06/2007
Operation
5 - 3
Advertisement
Table of Contents
