Funk Software Proxy User Manual page 59

If the station you want to connect to is on a different network segment, you must
prefix its network number and a colon (:) to the station name. For example, to
connect to station "Dell P200" on network number 2:
Note that the stationname may include wildcards.
Connecting by IP Address
To connect to a particular IP-based station by IP address, use the /P switch with
the name of the protocol, followed by the station's IP address or DNS name.
For example, to connect to the station at IP address 198.186.160.138, use the
following command line:
If the station you want to connect to has a DNS address, you can use it. For
example, to connect to station jackson.company.com, use the following
command:
Running a Task
To start up a task, specify the /T or /t switch, followed by the name of the task:
For example, to run a task called "report," use a command line like the following:
Customizing the Window Title
The title bar of a Proxy window normally has the caption "Proxy," along with the
name of the host PC to which you are connected and, if the connection was made
through a task, the name of the task.
If you'd like to replace the standard caption with one of your own choosing, use
the /W or /w switch. This switch must precede the workstation name, IPX
address, or task name.
62 Proxy: Chapter 6
PROXY /PIPX 2:Dell P200
PROXY /PIP address
PROXY /PIP DNS-name
PROXY /PIP 198.186.160.138
PROXY /PIP jackson.company.com
PROXY /Ttask
PROXY /Treport