Funk Software Proxy User Manual page 52

Protocols Setting
The Protocol tab dialog allows you to set which protocols you wish to allow the
host to use.
Figure 5-7: The Protocols Settings Dialog
A set of two checkboxes controls whether a Proxy Master will be permitted to
connect via IPX or IP protocol.
Each protocol that is currently available will have its address displayed. If a
protocol is currently unavailable then <not enabled> will be shown in place of
the network address.
If you check "IPX," you will allow a Proxy Master to see your host PC using the
IPX protocol, and connect to you via IPX.
If you check "IP," you will allow a Proxy Master to see your host PC using the
IP protocol, and connect to you via IP.
The Proxy Host 55