Messages / Malfunctions / Errors - Microlife PF 200 Instruction Manual

● Clear the last measurement
You can erase the last memory reading by pressing both memory scroll buttons
simultaneously for 5 seconds. After releasing the buttons «clr» will flash on
the screen for 3 seconds. To erase the last reading you need to press both
buttons again while the screen is flashing.
8. Analyse Data by Computer
The monitor can be connected via a USB connection port with a computer and all
memory data can be analysed by the Microlife Asthma Monitor software program.
Please contact your Microlife dealer.
Note: Please always use the latest version of the Analyzer to ensure up-to-date
performance and security. Remember to check the Microlife website or your
Microlife dealer for updates of the Analyzer software.
Warning!: To use the Microlfe Asthma Monitor software on your Windows
personal computer (PC), please make sure the Windows operating system is
up-to-date, with firewall and anti-virus software installed, to ensure the secure
operation of the software.
Warning!: Do not use the device if the QA sticker inside the battery compartment
is missing or damaged, as the device maybe susceptible to unauthorized
disassembly or tampering.

9. Messages / Malfunctions / Errors

If an error occurs one of the following listed error codes is displayed
Message Cause
Er2
Data communication between device
and computer does not work.
no There is no data stored in the monitor.
Hi The result is higher than 900 ml/min. This is a very good result.
Other possible malfunctions
If problems occur when using the device, the following points should be checked:
PF 200
Remedy
Check the cable connection
between device and computer.
14