Carrying Out A Measurement - Microlife PF 200 Instruction Manual

13. C lose the data compartment.
Please note:
● If you hold down the arrow key for more than 2 seconds it speeds up.
● D ate /time can also be set easily from computer when you run the Microlife
Asthma Analyser Software.

4. Carrying out a Measurement

● When different people use this meter their individual readings cannot be
assigned to different users when the data is stored.
● If time/date is not set, measurements can not be performed.
● I f another person intends to use the device permanently, all data from the
previous user should be erased as explained in this manual.
● I n case another user has already used the monitor, we recommend disinfecting
the measuring tube as explained in this manual. In this case we also
recommend that each user uses a new mouthpiece. Extra mouthpieces can be
ordered through your Microlife dealer.
1. P ress the ON/OFF button to turn the monitor
on. At first, the last result of the memory is
shown («0» if there is no data) and then
the device indicates «READY» for a measure-
ment by two short beeps and blinking arrows.
2. Y ou can perform the measurement while
standing or sitting upright. For better
comparison of your data you should always
perform the measurement in a similar position.
3. H old the monitor with both hands on the two
rubber areas (compartments).
4. I nhale completely and hold your breath for
a moment.
5. C over the mouthpiece tightly with your lips.
6. B low into the measuring tube as hard and as
fast as you can.
PF 200 8