Getting Started - NAUTICA J-CLASS User Manual

Getting Started

WARNING
Keep fingers away from gaps when folding the seascooter.
1. After battery installation, fold out the seascooter (Fig.10 step 1,2).
2. Lock the folded-out handles with the metal clips (Fig.10 step 3,4,5).
3. Slide the master switch to on position (Fig.11).
4. LCD dashboard will be switched on once master switch is in on position
(LCD will be switched off if seascooter is idle for 8 minutes. Slide the Master
Switch OFFand ON again to quit idle mode.)
5. Pull both triggers to start the propellors (Fig.11)
6. Release and press 1 trigger again to change the speed.
Unfold
Procedures
STEP 1
2. Flip both
handle backward
1. Flip both
handle locks open
STEP 2
Flip until two
handles stay inline
Fig.10
Trigger Trigger
ON
Fig.11
STEP 3
Flip left/right latch pins
to engage to the hooks
STEP 4
Left/right latch pins
engaged to the hooks
STEP 5
Push left/right lock
levers back down to
lock up both handles
MASTER
SWITCH
10
Attention: (Refer to Fig.12)
1) Seascooter should only be run in water. It will only run for 3 seconds if in air.
In such case "pictogram A" will be shown on the LCD screen
2) Seascooter should only be triggered when the handles are fully folded out.
Otherwise, "pictogram B" will be shown on the LCD screen.
3) Seascooter should only be triggered when the propeller grilles are installed
and locked. Otherwise, "pictogram C" will be shown on the LCD screen.
LCD display:
"pictogram A": When it is blinking, means you are not running the seascooter in
water.
"pictogram B": When it is blinking, means the seascooter handles are not fully
folded out.
"pictogram C": When it is blinking, means the grilles are not installed or locked.
"pictogram D": When it is blinking, means there is leaking of water in your
seascooter. In such case, the motor will run for 9 seconds then stop for 1 second
with beeping sound. Return to shore immediately and contact the service center
for repair.
Underwater Detection
Error Code (Blinks)
OFF
MASTER
SWITCH
Getting Started
Handlebar Detection
Nozzle Front Cap Detection
d
High Speed Zone
Medium Speed Zone
Low / Medium / High Speed
Low Speed Zone
Battery Level Bar
% Battery Capacity
Water Ingress Detection
(Blinks)
FIG-13
Battery capacity
indication
FIG-15
Medium speed
11
A
B C
FIG-12
Full Screen
D
FIG-14
Low speed
FIG-16
High Speed