NAUTICA J-CLASS User Manual page 7

Battery Instruction
Battery installation:
1) Ensure the master switch is in off position (Fig.11).
2) Always ensure the seascooter is out of water, dry and
placed in dry area.
3) Release the battery door locking screw according to Fig.3
step 1.
4) Slide out the battery door (Fig.3 step 2).
5) Make sure the terminals 0-rings on the battery and battery
compartment are in its position, clean and dry (Fig.9).
6) Align the groove on the battery and the tongue inside the
battery compartment, slide in the battery (Fig.4).
7) Lock the battery (Fig.5 step 1,2,3).
8) Close the battery door (Fig.6 step 1).
9) Lock the battery door (Fig.6 step 2).
To remove the battery for charging:
1) Unlock the battery (Fig.7 step 1,2).
2) Pull out the battery (Fig.8).
Battery Handle
LED Light
Battery
Match key slot
Charger
to load down
Charging battery to the
Base
charging base
Fig.2
Slide battery in with
Guiding tongue Guiding groove
battery guiding slot
inline with guiding rib
Fig.4
1. Turn locking screw
counterclockwise
to unscrew
battery door
2. Slide battery
door up to remove
Fig.3
1. Match inner
latch to the
3. Latched
battery slot
position
2. Push to rotate outer
Fig.5
latch to lock up battery
8
Battery Instruction
1. Pull and
flip battery
latch out
2. Pull and flip
Fig.7
battery handle out
2
1
1. Slide battery door down
2. Turn locking screw clockwise
to lock up battery door
Fig.6
Fig.8
Grip battery handle to pull battery out
1,2,3,4 BATTERY
SEAL RINGS
4
Fig.9
3
9