Camera Assembly; Care & Maintenance - NAUTICA J-CLASS User Manual

Camera Assembly

ATTACHING YOUR CAMERA TO SEASCOOTER MOUNTS
(Can be used with GoPro HERO [3, 3+, 4, 5, 6 or 7] cameras, or
®
other camera with using the same mount system)
To attach your camera to Seascooter J-CLASS, you will need a
thumb screw or hardware depending on the mount you are using.
Thumb Screw
Simply attach the Camera to the mount
and align the hole, Insert And Tighten Up
The Thumb Screw
*Camera (and Waterhousing), Attachment Buckle and Thumb Screw are not included
Fig.21
Waterhousing
3. Front grilles back in places
and fasten screws tight.
2. Matching cup/cone to reinstall front grilles
1. Remove screws and pull out front grilles
18
Care & Maintenance
Washing and Care
• After each use, immerse the seascooter into a container
filled with freshwater for 20 minutes. Then switch on the
seascooter in low speed for 3 seconds, and repeat this
function 5 times to wash away dirt and salt from the
product and motor.
• Dry the seascooter after washing. To dry the seascooter,
remove the battery and leave the battery door opened.
Turn the seascooter in different angles to drain the water.
Use a dry cloth to dry the seascooter. Put the seascooter
in a cool and ventilated area overnight for drying.
• Make sure the seascooter is fully dry before storage.
• To clean the Seascooter do not use detergents; only use
a damp cloth to wipe the unit clean.
• Use a cloth to dry the Seascooter and the battery
compartment.
• DO NOT leave the Seascooter in the water. Always take
the unit out of water when not in use.
Blocked Propeller
If the Propeller becomes blocked, you can remove the front grille
to remove an obstruction. Below steps must be following to
avoid injury.
(Under normal use the grilles must not be removed.)
1. Remove the SEASCOOTER from the water.
2. Make sure the master switch is in the Off position.
3. Dry the seascooter and remove the battery.
4. Open the grille according to the Fig.21 step 1.
5. Remove obstruction.
6. Reassemble grille (Fig.21 step 2,3).
Sand or Grit on Seals
Ensure that sand/grit does not get on the seals as correct
maintenance and care is essential. To remove sand or grit
from the seals, rinse the seals in fresh water and apply
fresh lubricant. If there is sand inside the Battery Housing,
gently brush the sand from the unit taking care not to
scratch the sealing surfaces.
19