Advertisement
How to Install
Easy setup
Set up your system in minutes
1
Plug Transmitter
into power outlet
Antenna
Power cable
Transmitter
(Remote Control )
DIAGRAM INSTALLING TRACKSTAFF V3 4 MESSAGE PAGING SYSTEM
1
Connect the two
antennas to the top
of transmitter
After plugging in the
antenna, twist it to
the right
1
Remove the pager
for the charging base.
2
Charging Base
* Top View
CAUTION
110V - 220V
NOTE: Surge
protector is
recomended
Connect the adapter to
the top right of
transmitter
* THEN, PLUG IT IN TO A POWER OUTLET
HOW TO USE
2
Type in the number
of the pager your
wish to activate.
Plug Charging Base
into power outlet
NOTE: Check
for solid
charging light
Power cable
2
110V - 220V
3
Press "SEND".
3
Set Pagers on top
of charging base
NOTE: Charge Pagers for 24 hrs before using
3
Place all pagers
on the charging
base
All pagers should
display a red charging
light ( This indicates
that the pagers are
charging )
4
To silence the
pager press the
side button.
Advertisement
