Table of Contents
Advertisement
Activation and parameterization | 4
4.2 Test mode
The motor current can be set and control commands can be distributed with the AS
Interface Handheld (Wieland 83.209.2204.0)
The addressing device operating mode "read and write data" may only be used
for testing purposes
• An existing AS-i connector is possibly disconnected on the M12 jack due to
plugging the cable from the AS-i manual control unit into the address jack on
podis
the
• Control-side interlockings are no longer effective.
• The drive can begin to move by setting the output data bits via the AS-i manual
control unit.
• Parameterization via the AS-i Handheld is intended exclusively for testing
purposes.
• Data is saved in non-volatile Flash storage via this operating mode. Default
parameters or current values transferred via slave profile 7.4 are overwritten.
The following motor currents can be selected via the Handheld:
Write
parameter
data
1
1
1
1
1
1
1
1
1
1
Procedure
1. First activate the slave that should have its settings changed (see section 5.1,
"Preparation").
2. Press the "MODE" button repeatedly until PARA appears in the display.
3. Set the value "1" with the
to the slave and distributed on the parameter port.
4. Now use the "MODE" button to set Data read/write. Then select with the buttons
or
the desired value from column 2 Data write of the
The value is transferred with the "PRG" key. The LEDs "M fwd" and "M rev" blink
simultaneously on the
26
WARNING
!
MCU
CAUTION
Write
Motor current
(Value on
address 0x0020)
1
0x0075
2
0x009A
3
0x00E5
4
0x012F
5
0x019F
6
0x0234
7
0x02CA
8
0x03F4
9
0x0544
A
Unchanged
or
key. By pressing "PRG", the value "1" is transferred
podis
MCU and thus display the changed settings.
Minimal current
Motor power [kW]
(Value on
address 0x0021)
0x0017
0,09
0x0017
0,12
0x0017
0,18
0x0017
0,25
0x0017
0,37
0x0017
0,55
0x0017
0,75
0x0017
1,1
0x0017
1,5
0x0000
Wieland Electric GmbH | BA000628 (Rev.A) | 04/2009
Advertisement
Table of Contents
