Tractel rollclamp Installation, Operating And Maintenance Manual

Tractel rollclamp Installation, Operating And Maintenance Manual

Advertisement

Quick Links

rollclamp, rollbeam, corso – EN 795
English
GB
Installation, operating and maintenance manual
Original manual
GB
Provisional portable anchor device

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the rollclamp and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Tractel rollclamp

  • Page 1 – EN 795 English Installation, operating and maintenance manual Original manual Provisional portable anchor device...
  • Page 2 – EN 795 Point d’ancrage provisoire transportable...
  • Page 4 L rollclamp M 476 mm 686 mm rollbeam 252 mm 168 mm M 30 30 mm 17 mm Rollbeam SB : 334 mm Rollbeam LB : 435 mm corso 380 mm max 4 mm 45 mm 210 mm 30 mm...
  • Page 5 R 13 kN min rollclamp w: 150 kg R 13 kN min rollbeam w: 150 kg R 13 kN min corso w: 150 kg...
  • Page 9 50 ou 60°...
  • Page 10: General Warning

    TRACTEL SAS. This manual should be available at for maintenance, for periodic inspections and all times to all operators. Additional copies can be repairs, all compiled in the language of the country supplied on request.
  • Page 11: Technical Specifications

    – rollclamp anchor devices. Figure 3. One of the main advantages of this equipment is * Length of the securing strap for rollclamp (Figure 1.1, that it can be secured at either above and below of Item 8): the anchoring beam. It can be installed on a wide rollclamp M: 580 mm range of anchoring beams of varying sizes.
  • Page 12: Associated Equipment

    – The beam must be free of any obstacles which could compliance with PPE Regulation 2016/425. Tractel ® distributes a range of PPE satisfying the requirements block or restrain the rollclamp or rollbeam anchor of this regulation and compatible with the Tractel device when moving. ®...
  • Page 13: Installation

    – Check after installation. installed (Fig. 2). 8.3.1. Opening the anchor device rollclamp additional check: rollclamp 1. The securing strap (fig. 1.1, item 8) does not show (fig. 5.1, item 1) any signs of wear or damage.
  • Page 14 8.3.3. Checking after installation The installer must check that: Check that the securing strap is not placed 1. The rollclamp or rollbeam anchor device slides between the beam and the guide rod (fig. 1, freely along the entire operator travel distance “C”...
  • Page 15: Using The System

    3. There is no risk of accidental unfastening of the 4. The securing strap does not show any signs of rollclamp or rollbeam identifiable along the entire breaks, tears or abnormal wear. operator travel distance “C” planned (fig. 4). 5. There is no risk of accidental unfastening of the 4.
  • Page 16: Prohibited Use

    U.V., etc.). with respect to the anchor device model. 21. To install a rollclamp or a rollbeam anchor device on 13. Prohibited use a beam having a slope with respect to the horizontal greater than 2°.
  • Page 17: Equipment Compliance

    Manufacturer’s name and address: 16. Periodic inspection and repair Tractel SAS - RD 619 - BP 38 Saint Hilaire sous Romilly An annual periodic inspection is required, but depending 10102 Romilly sur Seine...

This manual is also suitable for:

RollbeamCorso

Table of Contents