1. Battery charge indicator
•
If the battery charge indicator shows at least one full block, go to Step 3.
•
If the battery charge indicator does not show at least one full block:
A.
Move the key switch to the O
B.
Disconnect the battery. Refer to
C.
Verify that the battery charger is turned off.
D.
Connect the battery charger to the battery and charge the battery.
E.
Disconnect the battery charger and reconnect the battery to the machine.
F.
Turn on the machine by rotating the key switch to the O
G.
Look at the InfoCenter and see if the fault has repeated.
H.
Shut off the machine by rotating the key switch to the O
Pass
The fault did not repeat. Go to
listed.
Fail
The fault repeated. Go to Step 3.
Step 3: Access the main contactor.
1.
Verify that the key switch is in the O
2.
Disconnect the battery. Refer to
3.
Remove the white electric cover. Refer to
The main contactor is now visible.
Figure 28
position.
FF
Connecting and Disconnecting the Battery (page
Returning the Machine to Service (page 20)
position.
FF
Connecting and Disconnecting the Battery (page
Removing the Electric Cover (page
38
position.
N
position.
FF
and follow the steps
14).
17).
g364041
14).