Part 4: Installing The Tank And Hoses; Installing The Tank And Brackets - Vmac VR70 Installation Manual

Underhood air compressor

Hide thumbs Also See for VR70:

Table of Contents

Part 4: Installing the Tank and

The tank will mount to the passenger side frame rail

between the two body mounts (Figure 4.1).

Tank strap cable

Tank strap mount

C-clamp

□

Place the tank on a work bench with the front (oil filter end) of the

tank to your left. Remove the oil filter from the front of the tank.

□

Remove the two 1/4 inch clamp bolts from the C-clamps. Expand

the clamps slightly and slide them over the front of the tank.

□

Position the C-clamps about 6 inches from each end of the tank.

□

Place the two L-shaped tank strap mounts under the C-clamps with

the right-angle ends facing you and hanging over the edge of the

work bench.

VMAC – Truck Mounted Air Compressors

Toll Free: 1-888-241-2289

Fax: 1-250-740-3201

Hoses

Lower frame clip

Figure 4.1

Upper frame clip

Spacer

5/16" nuts and

washer

1/4" and 3/16" tubes

3/4" hose fitting

1/2" hose fitting

Oil filter

Table of Contents