Part 3: Installing The Tank And Hoses; Installing The Tank And Brackets - Vmac VR70 Installation Manual

Underhood air compressor

Hide thumbs Also See for VR70:

Table of Contents

Part 3: Installing the Tank and

The tank mounts under the driver's side step (Figure 3.1).

Cut-out

step

brackets

□

Remove the step from the truck. Place the supplied template on

the rear of the step back support panel and cut a half-crescent

section out of the lower part of the existing cut out section.

Repeat this operation with the front step support panel.

□

Slide the two C-clamps over the front of the tank, position the

clamps at the front and rear of the tank and loosely install the

pinch bolts in the clamps.

□

Pass the tank through the cut out section in the front step

support panel then align the tank through the rear cut-out in the

rear step support panel.

VMAC – Vehicle Mounted Air Compressors

Toll Free: 1-800-738-8622

Fax: 1-250-740-3201

Hoses

Tank

C-clamp bolts

Figure 3.1

FRONT

Table of Contents